Easiest Homemade Windmill Plans for Wind Power

Easiest Homemade Windmill Plans for Wind Power 1

Easiest Homemade Windmill Plans for Wind Power

Parts List Below.
This is the easiest homemade windmill you will find!

CORRECTION! In the video I said 3000w generator… I meant to say 300w… sorry about that. (senior moment) Also, my total cost was a little under $200.
Parts List Below:

27″ Snow Shovels — 4″ Round Weatherproof Box — 4″ Round Weatherproof Cover — Galvanized Pipe Nipple, 3/4-Inch X 12-Inch — EMT Snap N Set Screw Connector, 3/4″ — J-B Weld — Self-Drilling Screws — Pillow Block Bearings —
You will also need a stick of 3/4″ EMT electrical conduit.

New Find! – 750 Watt Permanent Magnet Alternator for Wind Turbine Generator. Check it out here:
NOTE: Just weld a nut on the bottom of your 3/4″ EMT conduit and screw this baby on… simple connect.

That’s it! Go Green! Mountain Mike
Help Support Our Solar Habits…
Please Visit for the Newest 2013 Toys & Gifts.